Heatec Tec-Note : Programing Honeywell UDC3300 modulating controllers on HC & HCS heaters page 2

Pages: 1, 2, 3, 4, 5, 6, 7, 8

Figure 3 (Part 1). Programming Honeywell UDC3300 (Modulating Controller) for Heatec HC and HCS heaters
Group Prompt (SET UP button)	Function Prompt (FUNCTION button)	Value or Selection (up / down arrows)	Group Prompt	Function Prompt	Value or Selection
TUNING	PROP BD	10.0	ALGORTHM	CONT ALG	PID A
	GAIN			TIMER	DISABL
	GAINVALn	Read Only		PERIOD
	RATE MIN	1.00		START
	RSET MIN			LDISP
	RSET RPM	5.00		INP ALG1
	MAN RSET			MATH K
	PROPBD2			CALC HI
	GAIN 2			CALC LO
	RATE2MIN			ALG1 INA
	RSET2MIN			ALG1 INB
	RSET2RPM			ALG1 INC
	CYC SEC			PCO SEL
	CYC SX3			PCT CO
	SECURITY	0		ATM PRES
	LOCKOUT	CALIB
	AUTO MAN		OUT ALG	OUT ALG	CURRNT
	SP SEL			4-20 RNG
	RUN HOLD			OUT2 ALG
				RLYSTATE
SPRAMP	SP RAMP	DISABL		RLY TYPE
	TIME MIN
	FINAL SP		INPUT 1	IN1 TYPE	J TC L
	SP RATE	DISABL		XMITTER1
	EU/HR UP			IN1 HI	770.0
	EU/HR DN			IN1 LO	20.00
				RATIO 1	1.000
				BIAS IN1	0.0
ACCUTUNE	FUZZY	DISABL		FILTER 1	1
	ACCUTUNE	DISABL		BURNOUT1	UP
	AT ERROR			EMMISIV1

			INPUT 2	IN2 TYPE
				XMITTER2
				IN2 HI
				IN2 LO
				RATIO 2
				BIAS IN2
				FILTER 2
				BURNOUT2
				EMMISIV2